BS 1726-1 | Mecmesin

Switch to solutions by

Provides guidance on methods of specifying and tolerancing hot coiled compression springs, and cold coiled springs that fall outside the size range limits specified in BS EN 15800. In addition, this standard includes in Annex A the general testing methods for parallel sided helical compression springs that are applicable to both hot and cold coiled springs manufactured from circular section material.

This standard gives two methods of specifying springs for general purposes and one method of testing springs.

Test types

compressive strength

Products tested

Springs

BS 1726-1_{Cylindrical helical springs made from round wire and bar. Guide to methods of specifying and tolerancing hot coiled springs, and cold coiled springs not covered by BS EN 15800, and general spring testing. Part 1, compression springs}

Some of our customers

Featured case studies

BS 1726-1Cylindrical helical springs made from round wire and bar. Guide to methods of specifying and tolerancing hot coiled springs, and cold coiled springs not covered by BS EN 15800, and general spring testing. Part 1, compression springs

Search results

Some of our customers

Featured case studies

BS 1726-1_{Cylindrical helical springs made from round wire and bar. Guide to methods of specifying and tolerancing hot coiled springs, and cold coiled springs not covered by BS EN 15800, and general spring testing. Part 1, compression springs}